Record Power CL3-CAM Original Instruction Manual page 15

6. Assembly Instructions - cont.
CL3-CAM Headstock Assembly
Kg
Please note: It is much easier to assemble
the headstock with the CL3-CAM motor
removed. See below for instructions on
how to remove the motor.
i
1. Disconnect lathe from power source.
2. Remove headstock cover, slacken the belt
tensioner Fig.6.16 and remove the drive belt
from the motor pulley, Fig 6.17.
3. There is a hole in the motor pulley, Fig 6.18,
which contains 2 grub screws, Fig 6.19. Remove
both screws, Fig 6.20, keeping them safely to
one side for re-assembly.
4. Completely remove the belt tensioning lever by
holding the nut on the inside of the head stock
securely whilst unscrewing the lever, Fig 6.21
After removal, keep both the nut and lever safe
for re-assembly.
5. Lift the motor and the motor plate casting from
the lathe headstock Fig.6.22.
6. Carefully lever the motor pulley off the motor
shaft Fig.6.22.
Fig.6.16
i
Tension lever
Fig.6.18
Grub screw insert
Fig.6.20
Fig.6.22
Fig.6.17
Fig.6.19
The pulleys lock onto the shafts using two
grub screws.
A knurled base grub screw
which locates into the
dog grub screw.
Then the dog grub screw
locates into the groove
on the shaft.
Fig.6.21
Belt tension lever nut Belt tension lever
15