Basic Specifications; Unpacking; Set Up Instructions; Assembly - Pacific hydrostar 65078 Set-Up & Operating Manual

Basic sPeciFicatiOns

Type
Fuel
Capacity
Type SAE
Engine Oil
Capacity
Pump Oil
Engine Speed
Engine Family
Water Flow
Maximum Pressure
note: Additional specifications found
in the TECHNICAL ENGINE
SPECIFICATIONS chart in this
manual.
The emission control system for
this Generator's Engine is warranted for
standards set by the U.S. Environmental
Protection Agency. For warranty
information, refer to the last pages of this
manual.
At high altitudes, the engine's
carburetor, governor (if so equipped), and
any other parts that control the fuel-air
ratio will need to be adjusted by a qualified
mechanic to allow efficient high-altitude
use and to prevent damage to the engine
and any other devices used with this
product.

unPacKing

When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
Page 8 For technical questions, please call 1-800-444-3353.
86+ octane unleaded
gasoline
0.95 Gallons
10W30 above 32° F
5W30 at 32° F or below
0.63 Quarts
150ml (5 Oz.) SAE
10W-30 Non-detergent
3,600 RPM
7CGPS.1961 GA : EM
3 GPM Maximum
2,800 PSI

set uP instructiOns

read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
warning
in serious personal injury.
turn the Power switch of the
equipment to its "OFF"
position, wait for the engine to
cool, and unplug the spark
plug wire(s) before
assembling or making any
adjustments to the equipment.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

assembly

1. This equipment has a spark
arresting muffler included. A spark
arresting muffler is required by law
in California, on some US Forest
Service land, and possibly in other
areas or situations.
2. Attach the Handle (14) onto the
Frame (17) with the Handle Bolts (15)
and Nuts (16).
3. Attach the Hose (18) to the Hose
Connection on the unit. (See picture
on the next page.)
4. Pull the Collar at the end of the hose
back and attach the Gun (19) to the
hose.
risk of accidental
starting; resulting
rev 09c
SKU 65078