Appendix; Configuring Your Pc' Sip Address; Configure Windows Xp For Dhcp - D-Link DPH-C160S User Manual

D-link dect cordless voip phone handset + base station

Hide thumbs Also See for DPH-C160S:

Table of Contents

DPH-C160S – DECT Cordless VoIP Phone – User Manual

Appendix

Configuring your PC's IP Address

In order to configure your system to recei e IP settings from the Router it must

first have the TCP/IP protocol installed. If you have an Ethernet port on your

computer, it probably already has TCP/IP protocol installed. If you are using

Windows XP the TCP/IP is enabled by default for standard installations. Below

is an illustrated example of how to configure a Windows XP system to

automatically obtain IP settings from the Router. Following this example is a

step-by-step description of the procedures used on the other Windows

operating systems to first check if the TCP/IP protocol has been installed; if it is

not, instructions are provided for installing it. Once the protocol has been

installed you can configure the system to receive IP settings from the Router.

For computers running non-Windows operating systems, follow the instructions

for your OS that configure the system to receive an IP address from the

Router, that is, configure the system to be a DHCP client.

If you are using a Router to provide Internet access for more than

one computer, you can use these instructions later to change the IP

settings for the other computers. However, you cannot use the same

IP address since every computer must have its own IP address that is

NOTE

unique on the local network.

Use the following steps to configure a computer running Windows XP to be a

DHCP client.

1. From the Start menu on your desktop, go to Control Panel.

From the Start menu, go to

Control Panel.

Page 60 of 67

Table of Contents