Toshiba e-STUDIO181 Service Handbook page 124

(7) Insert the gauge "0.40" of the doctor sleeve
jig into the gap between the developer
sleeve and doctor blade. Confirm that the jig
moves smoothly to the front and rear side,
and the gauge "0.50" cannot be inserted into
the gap.
(8) Confirm that the side seals are attached on
the toner scattering prevention sheet.
(9) Attach the developer unit upper cover and
tighten 2 screws.
Note:
After the developer material has been
replaced, adjust the auto-toner sensor.
(See P.3-1 "3.1 Adjustment of Auto-Toner
Sensor".)
e-STUDIO181/211
ADJUSTMENT
Doctor sleeve jig
Developer
sleeve
Side seal
© 2009 TOSHIBA TEC CORPORATION All rights reserved
3 - 42
Fig. 3-34
Toner scattering
prevention sheet
Fig. 3-35
Developer
unit upper cover
Fig. 3-36