Changing The Basic Settings; Care And Cleaning; Cleaning Products - Siemens HB23.B..0 Series Instruction Manual

Changing the basic settings

This oven has different basic settings. The settings can be
adapted to the user's own needs.
Basic settings
Time indicator
™‚
Duration of signal
™ƒ
after the cooking
time or the time set
on the timer has
elapsed
Time until a setting is
™„
applied
* Default setting

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.

Cleaning products

Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners
■
Wash new dishcloths thoroughly before use.
Selection
Selection ‚ Selection ƒ
„
always* only with -
the
button
0
approx. approx. approx.
10 sec 2 min.* 5 min
approx. approx. approx.
2 sec 5 sec.* 10 sec.
No other time function can be programmed.
Press the button for approximately 4 seconds.
0
1.
The display panel will show the current basic setting for the
time, e.g. for the Selection
™‚
Set the basic setting using the buttons
2.
Confirm with the button.
0
3.
The display panel shows the following basic setting. Using
the button select the levels and using the buttons
0
make the setting.
Press the button for approximately 4 seconds.
0
4.
All basic settings have been applied.
The basic settings can be changed again at any time.
Zone Cleaning products
Front panel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass cleaning
product or a glass scraper.
Stainless steel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or egg
white stains since corrosion could
occur underneath these marks or
stains.
Special products for the care of stain-
less steel and which are suitable for hot
surfaces may be obtained from Techni-
cal Assistance Service centres and spe-
cialist retail outlets. Use a very fine soft
cloth to apply the cleaning product.
Glass panel Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Display Glass cleaning products:
Clean using a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass panels on oven Glass cleaning products:
door Clean using a soft cloth. Do not use a
glass scraper.
Glass cover for the Hot water and a little soap:
oven light Clean with a dishcloth.
The seal Hot water and a little soap:
Do not remove! Clean with a dishcloth. Do not rub.
Wire shelves or rails Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do
not leave this to soak or wash in a dish-
washer.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
.
‚
@ or A .
or
@ A
9