Adjusting The Horizontal Magnetic/Micr Closing Flap - Olivetti PR2 PLUS Service Manual

Adjusting the horizontal magnetic/MICR closing flap

•
MACHINE STATUS
– Printer switched off and without casing..
– Read/write carriage in reset position (end of stroke motor side) and screw (1) which joins the semi tie-rods
loosened.
•
CONDITIONS TO BE CHECKED
Co-planarity between the closing flap and the front surface of the structure.
•
PROCEDURE
Position the flap (2) in contact with the slot (3) operating in the compartment between the fork and toothing of
the semi tie-rods (4); then, tighten the screw (1).
Adjusting the horizontal magnetic/MICR closing flap
Figure 6 - 11
6-12
1 4
Adjustment
area
Service Manual
3
2
XZAC4219-05