Sony VPL-X2000U Service Manual page 11

Location and Function of Controls
Front
2
3 4 5
1 Lens mount part
When attaching the optional lens, consult with the
Sony service personnel.
2 Speaker
3 Front remote control detector
4 Bottom ventilation holes (intake)
Do not block the holes.
5 Adjusters
Use the adjusters to keep the projector level if it is
installed on an uneven surface.
6 Front ventilation holes (intake)
Do not block the holes.
7 Adjuster button and lever
Press the button to raise the lever for adjusting the
height of the adjuster.
8
(GB)
1
!º
6 7 8 9
8 Handle lever (left and right sides)
Use the lever for putting away the carrying handle.
9 Carrying handle (left and right sides)
Pull out the handle for carrying the projector.
!º Left and right side ventilation holes (exhaust)
Do not place anything within the 30 cm (11 7 / inches)
8
range from these holes or block them.
Notes
• Do not block the ventilation holes, or internal heat
build-up may occur, causing fire or damage to the
projector.
• Do not place anything near the ventilation holes or
touch these holes as the temperature will be very
high.
Using the carrying handles
Pull out to use for carrying the projector. To put away
the handle, slide the handle lever forward.
Using the adjusters
To lower the
projector
To raise the
projector
Adjuster button
1
Press the adjuster button.
The adjuster lever comes out.
2
Turn the lever to adjust the height so that the
projector becomes level.
3
Replace the adjuster lever after use.
9
(GB)