Air Cleaner Box And Throttle Body Installation - Suzuki SV650 Supplementary Service Manual

AIR CLEANER BOX AND THROTTLE BODY
INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points:
• Connect the throttle pulling cable 1 and throttle returning
cable 2 to the throttle cable drum.
• Loosen each throttle cable lock-nut.
• Turn in each throttle cable adjuster fully and locate each outer
cable so that the clearance is 0 mm (0 in).
• Tighten each lock-nut.
• Adjust the throttle cable play. (#SV650/SK3 2-16)
• Connect the fuel injector couplers to the fuel injectors. Make
sure that each coupler is installed in the correct position. The
color on each lead wire coupler refers to the appropriate fuel
injector.
Front injector lead wire coupler 3: Brown
Rear injector lead wire coupler 4: Gray
• Connect the TP sensor lead wire coupler 5 and STP sensor
lead wire coupler 6.
%
TP sensor lead wire coupler and STP sensor lead wire
coupler resemble each other very closely in external
appearance.
Make sure to check the color of coupler before install-
ing.
TPS lead wire coupler 5: Gray
STPS lead wire coupler 6: Black
• Install the air cleaner box and tighten the throttle body clamp
screws as shown in the illustration. (#Page 145)
SV650K7/SK7/AK7/SAK7 ('07-MODEL)
0 mm (0 in)
0 mm (0 in)
59