Suzuki SV650 Supplementary Service Manual page 84

PRE-DIAGNOSIS INSPECTION
The mechanical and hydraulic components of the brake system should be inspected prior to performing any
electrical checks. These inspections may find problems that the ABS could not detect; thus, shortening
repair time.
BRAKE
Brake fluid level check (#SV650/SK3 2-25)
Brake pad inspection (#SV650/SK3 2-26)
Brake fluid circuit air bleeding (#SV650/SK3 2-27)
TIRE AND WHEEL
Tire type :
Front : DUNLOP D220FST (SV650A)
: DUNLOP D220FST M (SV650SA)
Rear : DUNLOP D220ST L
%
* The standard tire fitted on this motorcycle is 120/
60ZR17M/C 55W for front and 160/60ZR17M/C 69W
for rear. The use of tires other than those specified
may cause instability. It is highly recommended to
use a SUZUKI Genuine Tire.
* Replace the tire as a set, otherwise the DTC "25"
(C1625) may be stored.
Tire pressure (#SV650/SK3 2-29)
Wheel (#SV650/SK3 7-10 and -89)
BATTERY
Battery voltage
• Turn the ignition switch to OFF.
• Remove the front seat. (#SV650/SK3 7-4)
• Measure the voltage between the + and - battery terminals
using the multi-circuit tester.
$ Battery voltage: 12.0 V and more
" 09900-25008: Multi-circuit tester set
' Tester knob indication: Voltage (()
If the voltage is less than 12.0 V, charge or replace the battery
and inspect the charging system. (#SV650/SK3 8-7)
SV650K7/SK7/AK7/SAK7 ('07-MODEL) 83