Removing A Floppy Drive; Installing A Floppy Drive - Dell Precision Workstation 470 User Manual

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.

Removing a Floppy Drive

1. Follow the procedure in
2. Disconnect the power and floppy-drive cables from the back of the floppy drive.
3. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive
bay.
1 power cable
2 floppy-drive cable
3 tabs (2)
4 floppy drive

Installing a Floppy Drive

1. If you are replacing a drive and the new drive does not have the bracket rails attached, remove the rails from the old
drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the
screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two
screws on each rail).
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
"Removing and Replacing Parts."