Processor Airflow Shroud - Dell Precision Workstation 470 User Manual

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
1. Follow the procedures in
2. Press the lever on the card retention arm and raise the retention arm.
3. If necessary, disconnect any cables connected to the card.
4. If your card includes a card retention bar, remove the bar.
5. Gently pull back and hold the securing tab, grasp the card by its top corners, and then ease it out of its connector.
6. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket,
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
7. Lower the retention arm and press it into place, securing the card(s) in the computer.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
8. Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
9. Remove the card's driver from the operating system.
10. If you installed a sound card:
a. Enter system
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the
microphone, speaker/headphone, or line-in connectors on the back panel.
11. If you installed an add-in network adapter:
a. Enter system
Off.
b. Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the
integrated connector on the back panel.
12. Install any drivers required for the card as described in the card documentation.

Processor Airflow Shroud

Installing the Airflow Shroud
CAUTION: Before you perform this procedure, follow the safety instructions located in the Product
Features Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer's electronic components. You can do so by touching an
unpainted metal surface on the computer chassis.
1. Follow the procedures in
2. If you have added a second processor to your computer:
a. Remove the airflow shroud insert.
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
"Removing and Replacing
contact Dell.
setup, select Integrated Devices, and then change the setting for Sound to Off.
setup, select Integrated Devices, and then change the setting for Network Interface Card to
"Removing and Replacing
Parts."
Parts."