When To Use The Dell Diagnostics; Starting The Dell Diagnostics From Your Hard Drive; Starting The Dell Diagnostics From The Drivers And Utilities Cd - Dell Precision Workstation 470 User Manual

Hide thumbs Also See for Precision Workstation 470:
Table of Contents

Advertisement

Tools to Help Solve Problems: Dell Precision Workstation 470 and 670 Computers User's Guide
Write fault on selected drive —
See
"Drive
Problems."
x:\ is not accessible. The device is not ready —
disk into the drive and try again.
Dell Diagnostics
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.

When to Use the Dell Diagnostics

If you experience a problem with your computer, perform the checks in
before you contact Dell for technical assistance.
It is recommended that you print these procedures before you begin.
NOTICE:
The Dell Diagnostics works only on Dell™ computers.
Enter system
setup, review your computer's configuration information, and then ensure that the device you want to test
displays in system setup and is active.
Start the Dell Diagnostics from either your hard drive or from the Drivers and Utilities CD (also known as the ResourceCD).

Starting the Dell Diagnostics From Your Hard Drive

1. Turn on (or restart) your computer.
2. When the DELL™ logo appears, press <F12> immediately.
NOTE:
If you see a message stating that no diagnostics utility partition has been found, run the
your Drivers and Utilities CD.
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows®
desktop. Then shut down your computer and try again.
3. When the boot device list appears, highlight Boot to Utility Partition and press <Enter>.
4. When the Dell Diagnostics Main Menu appears, select the test you want to run.

Starting the Dell Diagnostics From the Drivers and Utilities CD

1. Insert the Drivers and Utilities CD.
2. Shut down and restart the computer.
When the DELL logo appears, press <F12> immediately.
If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut
down your computer and try again.
file:///T|/htdocs/systems/ws670/EN/ug_en/advtrbl.htm[3/20/2013 9:31:57 AM]
The floppy drive cannot read the disk. Insert a floppy
"Solving
Problems" and run the Dell Diagnostics
Dell Diagnostics
from

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Precision workstation 670

Table of Contents