Advertisement
Subnet Mask — Enter the subnet mask provided by your ISP (for
example, 255.255.255.0).
Default Gateway — Enter the IP address of the ISP gateway.
User ID — Enter the username provided by your ISP for the PPTP
connection.
Password — Enter the password provided by your ISP for the PPTP
connection.
PPTP Gateway — If your LAN has a PPTP gateway, enter that PPTP
gateway IP address here. If you do not have a PPTP gateway, enter
the ISP's gateway IP address (listed above).
Connection ID — This is the ID given by the ISP. This is optional.
MTU — Enter the MTU value provided by your ISP for the PPTP
connection.
BEZEQ-ISRAEL — Select if you are using the service provided by Bezeq
in Israel.
Connection Type — Choose one of three drop-down menu options:
• "Continuous": Keeps the router connected to the ISP. If the WAN
connection is disrupted and then re-linked, the router will automatically
reconnect to the ISP.
• "Connect On Demand": Auto-connects the router to the ISP when
a user wants to use the Internet, and keeps it connected until the
WAN idle timeout. The router will close the WAN connection if the
time period of Internet non-use exceeds the Idle Time setting.
• "Manual": Connects the router to the ISP only when you click
"Connect" on the Web user interface. The WAN connection will not
disconnect due to the idle timeout, and if the WAN connection is
disrupted and re-linked, the router will not auto-connect to the ISP.
Idle Time Out — You can specify an idle-time threshold (in minutes) for
the WAN port. If no packets have been sent (no one has been using
the Internet) throughout this specified period, the router will automatically
disconnect from your ISP.
Click "OK" to finish the PPTP configuration; then you can start using the
router.
L2TP
Select if your Internet service provider requires the L2TP protocol to
12
Advertisement
