Selecting Water Hardness Level - Electrolux 60 cm Series Service Manual

3 "ECO DRYING" button
- Press to exclude the drying function. The LED lights when ECO DRYING has been selected.
- Press again to reset the appliance to normal drying. The LED switches off.
"ECO DRYING" LED (green)
- ON: ECO DRYING activated
- OFF: ECO DRYING disactivated
4 "DELAYED START" button
- Press to enter the number of hours of delayed start for the programme selected
- The LED flashes while the DELAYED START option is being selected
- Transmits a signal which is displayed on the "DIGIT" window in the form of a number (from 1 to 9)
"DELAYED START" LED (green)
- FLASHES while the number of hours is being selected
- LIT while the countdown is in progress
- OFF during selection and execution of the washing programme
5 "CANCEL" button
- This button is enabled only when the door is open
- Must be held down for at least 2 seconds
- In the Programme Selection phase, cancels all selections entered
- If pressed while the programme is in progress, interrupts and cancels the cycle
SELECTING THE WATER HARDNESS LEVEL
OPEN THE DOOR:
Set the appliance to the Programme Selection phase
SWITCH ON THE DISHWASHER:
If necessary, press the "ON/OFF" button.
- Press the "ECO DRYING" and "CANCEL" buttons (3 + 5)
simultaneously, and hold them down for 5 seconds until
the previously-selected hardness level (0 to 9) is displayed
on the DIGIT window.
- To modify the hardness level, press the "ECO DRYING"
button (3) while the corresponding LED is flashing.
The setting increases by one level each time the button is
pressed.
- 5 seconds after pressing the button for the last time, the hardness level displayed on the DIGIT window
is stored in memory.
The appliance automatically returns to the Programme Selection phase.
- 33 -