First Alert
ReadyGuard-REN
User Manual page 28

86(5)81&7,216
Scheduling User Interface
Entry Event
0 Empty
1 X-10 Device
2 Latch Key Report
3 Automatic Stay Arming
4 Reminder Announcements
5 Alarm Clock
† The beeping sounds will be terminated when any key is pressed during a remote phone control session.
Event Identifier Entries
No event scheduled (or schedule is temporarily disabled)
Turn an X-10 device, either on or off at begin/end times. (will
have a start and end time to program) (time driven)
NOTE: SH10A siren cannot be used.
Send a special pager report (7110000) indicating system not
yet disarmed. (will have a start/end time to send the report)
(window driven), (reports only to pager)
NOTE: Option *49 must be programmed to be 6 or higher.
Make sure unit is armed prior to start of window time.
In addition a secondary phone number must be
programmed in Option *42.
Will arm the system automatically, and bypass any open
zones, at a given time. It will send a report to the pager and
central station, indicating system has been auto armed stay,
plus all bypass reports. (will have only a start time to send the
report) (time driven)
NOTES: (1) Prior executing auto stay arming, force bypass
will be executed - if option *23 was enabled.
(2) If pager report is required, Option *49 must be
programmed to be 6 or higher.
Will beep three times and then announce custom words 72,
73 and 74. This will be repeated every minute until a key is
depressed, or a button type zone does an arm or disarm.
NOTE: Make sure installer programmed custom words 72-74
at the time of installation.
Will start a trouble tone (beep) on the speaker, which will
continue until a key is depressed.
Figure 1.
– 28 –
Comment
†
†