80 Hz High Pass Filter; Boundary Compensation; Led Indication; Mounting - JBL LSR6312SP Owner's Manual

Switch 3 boosts the high frequency response by 1.5 dB above 2.3 kHz when set to the UP position. This posi-
tion can be used if the room is extremely dead, or you want to hear more high frequency from the speaker to
assist you in creating "warmer" mixes.
Switch 4 attenuates the high frequency response by 1.5 dB above 2.3 kHz when set in the UP position. This
position can be used if the room is highly refl ective or you want to hear less high frequency from the speaker
to allow you to mix "brighter," apply more high frequency EQ or signal processing.
80 Hz High Pass Filter – Setting DIP switch 1 in the UP position activates a 80 Hz High-Pass fi lter. This fi lter
can be activated when LSR6325P is used with sub woofers that do not include bass management features.
Boundary Compensation – DIP Switch 2 can be used to restore accurate system performance when the
speaker is placed on a work-surface, or near wall or boundary. The setting is particularly useful when the
speaker will be positioned on a table-top and used with computer audio production system.
LED Indication – A single bi-color LED indicator is located on the front of the LSR6325P. In normal operation,
the LED will be illuminated GREEN. At the onset of amplifi er clipping in either the low or high frequency ampli-
fi er, the LED will fl ash RED. Continual RED illumination of this LED indicates that levels should be reduced.
Mounting – The LSR6325P has built-in mounting points for use with industry-standard mounting hardware.
The mounting points are located on the rear panel of the speaker system. The four threaded holes accept a
¼" diameter machine screw with a pitch of 20 threads per inch. The length of the screw should be a total of
5/8th inch plus the thickness of the mounting bracket.
����������������
��������
����������
����������
���������
������
�������������
����������������������
�����������������
������������������
�����������������������
��������������������������
���������������������������
Mounting Hole Pattern
9