Subscribe to Our Youtube Channel
Related Manuals for Clarke CONSN18LI
Summary of Contents for Clarke CONSN18LI
- Page 1 18V CORDLESS STAPLER/NAILER MODEL NO: CONSN18LI PART NO: 6487055 OPERATION & MAINTENANCE INSTRUCTIONS LS1213...
-
Page 2: Available Fasteners
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights. AVAILABLE FASTENERS The following packs of fasteners are available from your Clarke Dealer. Nails Part Staples... -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS, INCLUDING THE FOLLOWING, SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND PERSONAL INJURY. WARNING: READ ALL THESE INSTRUCTIONS BEFORE OPERATING THIS PRODUCT AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. For safe operation: 1. -
Page 4: Machine Specific
16. Stay alert. - Watch what you are doing. Use common sense. Do not operate tool when you are tired. 17. Check damaged parts. - A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this instruction manual. -
Page 5: Battery Charger
BATTERY CHARGER 1. Observe the mains voltage! The voltage of the power supply must correspond with the data given on the rating plate of the battery charger. 2. Keep the battery charger away from rain or moisture. Penetration of water into the battery charger increase the risk of electric shock. -
Page 6: How To Charge The Battery
HOW TO CHARGE THE BATTERY WARNING: THE BATTERY CAN BE WARM TO THE TOUCH WHEN REMOVED FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE RECHARGING. DO NOT RECHARGE A WARM BATTERY. NOTE: New batteries must be charged before use. 1. -
Page 7: Preparing The Stapler/Nailer For Use
PREPARING THE STAPLER/NAILER FOR USE FILLING THE MAGAZINE CAUTION: KEEP YOUR FINGERS WELL AWAY FROM THE TRIGGER, 1. Remove the battery from the stapler/nailer before filling the magazine. 2. Press and hold the magazine catch then pull out the magazine 3. -
Page 8: Using The Stapler/Nailer
USING THE STAPLER/NAILER ay attention to the SAFETY INSTRUCTIONS on page3. 2. Hold the tool securely and press the nose against the work as shown. • Always hold the stapler/nailer square to the workpiece, never at an angle. 3. Gently pull the trigger. 4. -
Page 9: To Clear A Jam
TO CLEAR A JAM Do not pull the trigger until the jam has been cleared, as this could cause serious damage: WARNING: REMOVE THE BATTERY FROM THE STAPLER/NAILER BEFORE CARRYING OUT ANY SERVICING OR MAINTENANCE 1. Remove the battery from the stapler/nailer. -
Page 10: Maintenance
• Do not open the casing, the guarantee will be void if the casing has been opened or if the stapler/nailer has been tampered with. • The use of parts other than CLARKE replacement parts may result in safely hazards, decreased tool performance and will invalidate your warranty. -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the CONSN18LI and is the answer not in the manual?
Questions and answers