Related Manuals for Clarke Contractor CONSN18LIB
Summary of Contents for Clarke Contractor CONSN18LIB
- Page 1 18V CORDLESS STAPLER/NAILER MODEL NO: CONSN18LIB PART NO: 6487057 OPERATION & MAINTENANCE INSTRUCTIONS LS0116...
-
Page 2: Specification
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS, INCLUDING THE FOLLOWING, SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND PERSONAL INJURY. WARNING: READ ALL THESE INSTRUCTIONS BEFORE OPERATING THIS PRODUCT AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. For safe operation: 1. -
Page 4: Machine Specific
16. Stay alert. - Watch what you are doing. Use common sense. Do not operate tool when you are tired. 17. Check damaged parts. - A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre unless otherwise indicated in this instruction manual. -
Page 5: Battery Charger
BATTERY CHARGER 1. Observe the mains voltage! The voltage of the power supply must correspond with the data given on the rating plate of the battery charger. 2. Keep the battery charger away from rain or moisture. Penetration of water into the battery charger increase the risk of electric shock. -
Page 6: How To Charge The Battery
HOW TO CHARGE THE BATTERY WARNING: THE BATTERY CAN BE WARM TO THE TOUCH WHEN REMOVED FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE RECHARGING. DO NOT RECHARGE A WARM BATTERY. NOTE: New batteries must be charged before use. 1. -
Page 7: Preparing The Stapler/Nailer For Use
PREPARING THE STAPLER/NAILER FOR USE FILLING THE MAGAZINE CAUTION: KEEP YOUR FINGERS WELL AWAY FROM THE TRIGGER, 1. Remove the battery from the stapler/nailer before filling the magazine. 2. Press and hold the magazine catch then pull out the magazine 3. -
Page 8: Using The Stapler/Nailer
USING THE STAPLER/NAILER ay attention to the SAFETY INSTRUCTIONS on page3. 2. Hold the tool securely and press the nose against the work as shown. • Always hold the stapler/nailer square to the workpiece, never at an angle. 3. Gently pull the trigger. 4. -
Page 9: To Clear A Jam
TO CLEAR A JAM Do not pull the trigger until the jam has been cleared, as this could cause serious damage: WARNING: REMOVE THE BATTERY FROM THE STAPLER/NAILER BEFORE CARRYING OUT ANY SERVICING OR MAINTENANCE 1. Remove the battery from the stapler/nailer. -
Page 10: Maintenance
• Do not open the casing, the guarantee will be void if the casing has been opened or if the stapler/nailer has been tampered with. • The use of parts other than CLARKE replacement parts may result in safely hazards, decreased tool performance and will invalidate your warranty. -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the Contractor CONSN18LIB and is the answer not in the manual?
Questions and answers