Advertisement
@
Input source display
l
Each press of the mput switching
button
(INPUT)
causesthe
lndlcators to ltght as described below.
CD
1
OPT
I
This lights when the Input so"lce 1s set
to the nternal CD.
Th,s lights when the DIGITAL IN
1
OPTICAL ,nput jacks are selected
COAX
This lights when the DIGITAL IN
1
COAXIAL Input jacks are selected
ANALOG
Th,s lights when the ANALOG CD-R IN
,np"t jacks are selected
0
Music calendar display
l
Tracks on a disc or I" a program
l
Track I" playlrecordlng.
*Off
when both the CD and CD-R tomes are displayed.
@
Multiple
display
l
This display
lndlcates
the number
of tracks,
track
number, play tnvz, recording tome, VBIIOUS operatlonal
Information. text messages, etc
l
When both the CD and CD-R times aie dlsplayed. the
CD-R time IS displayed
Q
Level meter
l
Record level bar. lndlcates the audio signal level
l
When the CD-R unit IS set to the recording mode, the
Input level IS dIsplayed
@
Track No. display
l
When there IS text information,
the track number IS
dlsplayed.
l
When both the CD and CD-R times are displayed. the
CD track number 1s displayed.
0
Time display
l
When there IS text Informatvan, the tme IS displayed
l
When both the CD and CD-R t!mes are displayed, the
CD time IS dIsplayed
cl
8 REMOTE CONTROL UNIT
n
The included remote control unit (IX-278)
can be used to operate the CDR-WI500
from a distance.
Inserting
the batteries
0 Remove the remote control unit's back Ild
0
Insert
the
two
R6P (AA)
batteries
I" the
battery
compartment,
I" the dIrectjon lndlcated by the marks InsIde
the compartment.
0 Put the back Ild back on
Using the remote
control
unit
Cautions
on batteries
l
Use R6P (AA) batteries I" the remote contlol unit
l
The batteries should be replaced with new ones after
approximately
one year, though this depends on the
frequency wth which the remote control un!t is used.
l
Even If the battews
are less than a year old, replace
them with new ones If the remote
control
unit no
longer operates even from a short distance from the
main untt
l
The Included battery IS only for verlfylng
operation
Replace It with a new batten/ as soon as possible.
l
When
,nsert,ng
new batteries,
wa!t
about
two
m,n"tes
after
removing
the old batteries
before
,nserting the new ones.
l
Be sure to set the batteries
I" the proper "0"
and
"0"
directlons.
as lndlcated
by the marks in the
remote control unit's battery compartment.
l
Remove
the battera
when not using the remote
control un,t for long perlods of t,me.
l
To avad explosions and fluId leakage:
l
Do not use one new battery with one old one.
. Do not "se two different types of battera
. Do not short-clrcut,
disassemble,
heat or dispose
of batteries I" flames.
l
If the battery fluld should leak, w~oe all the flud off
the battery compartment,
then insert new batteries
l
When operating the remote control ""It. point It at
the man unit es shown I" the diagram.
l
The remote control unit can be operated
from a
dnect dMance
of approxnately
8 meters
from
the ma," "nit.
This distance WIII be shortened.
however, if there are obstacles or when operated
from an angle.
(The remote
control
un,t WIII operate
from
a
horlrontal angle of up to about 30".1
NOTES:
l
The remote control ""It
may not operate If the remote
l
Do not press buttons on the ma," ""It and on the remote
sensor is exposed to direct sunlight
or strong artiflctal
control
"n,t at the same time. Doing so WIII result I"
light, or If there IS an obstacle between It and the remote
malfunction.
sense
9
Advertisement
