Using Silent Installation - Broadcom NetXtreme II User Manual

User Guide
January 2010
7. Click Install.
8. Click Finish to close the wizard.
U S I
SING ILENT NSTALLATION
NOTES:
• All commands are case sensitive.
• User must "Run as Administrator" for Vista when using "msiexec" for "silent" install/uninstall(s).
• For detailed instructions and information about unattended installs, refer to the Silent.txt file in the MgmtApps
folder.
To perform a silent install (or upgrade) from within the installer source folder
Type the following:
setup /s /v/qn
If performing a silent upgrade, your system may reboot automatically. To suppress the reboot, type the following:
setup /s /v"/qn REBOOT=ReallySuppress"
To perform a silent install and create a log file
Type the following:
setup /s /v"/qn /L f:\ia32\1testlog.txt"
The 1testlog.txt log file will be created at f:\ia32.
To perform a silent uninstall from any folder on the hard drive
msiexec /x "{26E1BFB0-E87E-4696-9F89-B467F01F81E5}" /qn
NOTES:
• The hexidecimal number above may differ from your current installer. Check the Key name corresponding with
t h e B r o a d c o m
HKLM\Software\Microsoft\Windows\CurrentVersion\Uninstall for the correct hexidecimal number.
• After performing a silent uninstall, it is necessary to reboot the system before reinstalling this installer. If a reboot
is not performed, BASP will not install correctly.
To perform a silent install by feature on IA32 platforms
Use ADDSOURCE to include any of the features listed below.
NOTE: CHM32 or CHM64 installs the BACS help file and must be included when installing the BACS feature.
setup /s /v"/qn ADDSOURCE=BACSi32,CHM32,BASPi32,SNMPi32,CIMi32"
To perform a silent install by feature on AMD64/EM64T platforms
Document ENGSRVT52-CDUM100-RInstalling Broadcom Advanced Control Suite 3 and Related Management Applications Page 105
A d v a n c e d C o n t r o l
Bro adco m Co rp or atio n
S u i t e 3 ( B A C S )
NetXtreme II
a p p l i c a t i o n i n