Displaying The Picture - Christie LX41 Setup Manual

Displaying the picture

1. Activate your signal source. Turn the
signal source on, and make it send the
signal to the projector.
Use the VOLUME + / VOLUME - buttons
2.
to adjust the volume.
To have the projector silent, press the
MUTE button on the remote control.
3. Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from
the HDMI, COMPONENT (Y, Cb/Pb,
Cr/Pr), S-VIDEO or VIDEO port, or the
COMPUTER button for selecting an
input signal from the COMPUTER IN1,
COMPUTER IN2, LAN, USB TYPE A or
USB TYPE B port.
4. Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
5. Use the ZOOM ring to adjust the screen
size.
6. Use the FOCUS ring to focus the picture.
7. Turn the VERTICAL adjuster fully counter
clockwise. Then turn it clockwise and
adjust the vertical lens position upward.
8. Turn the LOCK counter clockwise to
loosen the lock of the HORIZONTAL
adjuster.
Turn the HORIZONTAL adjuster
9.
clockwise or counter clockwise to adjust
the horizontal lens position.
10. Turn the LOCK fully clockwise to tighten it
and lock the horizontal lens position.
(continued on next page)
LX41/LW41 Setup Guide
VIDEO COMPUTER MY SOURCE/
ASPECT AUTO
MAGNIFY FREEZE
ON
OFF
MY BUTTON
KEYSTONE
POSITION
ENTER
ESC
INPUT button
VIDEO COMPUTER MY SOURCE/
ASPECT AUTO
MAGNIFY FREEZE
ON
OFF
MY BUTTON
KEYSTONE
POSITION
ENTER
ESC
10
DOC.CAMERA
SEARCH BLANK
PAGE VOLUME
UP
VOLUME+ button
DOWN
VOLUME- button
MUTE
MUTE button
MENU
RESET
VIDEO button
DOC.CAMERA
COMPUTER button
SEARCH BLANK
PAGE VOLUME
UP
ASPECT button
DOWN
MUTE
MENU
RESET
FOCUS ring
ZOOM ring
LOCK
(horizontal lens
position lock)
HORIZONTAL
adjuster
VERTICAL
adjuster
020-000510-01 Rev. 1 (06-2012)