Error Messages During File Transmission - Xerox 7142 Service Manual

9 Troubleshooting
9.2.6

Error Messages During File Transmission

This section describes the error messages displayed when sending backup parameters and firmware using
dedicated online software, as well as their recovery actions.
No. Message
1 Transfer failed
Data format
error
2 Transfer failed
Aborted by the
HOST
3 Transfer failed
Data timeout
4 Transfer failed
Check-sum
error
5 Transfer failed
Incompatible
F/W
6 Transfer failed
Flash erase
error
7 Transfer failed
Flash write
error
8 Transfer failed
Flash compare
error
9 Transfer failed
Flash error FFF
Table 9-8 Error Messages During File Transmission
Event/ Check item
symptom
Firmware data Check if transferred
format is firmware is an
inappropriate. appropriate file.
Cancel button -
on PC has been
pressed.
Communication Check connection
time-out between plotter and PC.
occurred.
File checksum -
error.
Incompatible Check if program file is
firmware. appropriate.
ROM erase Board may be defective. Replace board.
error.
ROM writing
error.
ROM writing
error.
ROM writing
error.
RJ-901C/RJ-900C Maintenance Manual
After confirming it,
install firmware again.
Transfer firmware
again.
After resolving
problem, transfer
firmware again.
1. Transfer firmware
again.
2. If error message is
still displayed,
check if transferred
firmware is an
appropriate file.
After confirming it,
install firmware again.
9-32
Action Reference
"7.3.5
Firmware
Installation"
p.7-15
"7.3.5
Firmware
Installation"
p.7-15
"4.3.3
Replacing
Main Board
Assembly"
p.4-21