Adjusting The Image Size - Epson EB-1775W User Manual

Adjusting Projected Images
e
Using the [ ], [
remote control, or the [
control panel, correct the position of the corner.
If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen from step 3 is displayed when you press the [
[ ], [ ], and [ ] buttons on the control panel next time.
Change Keystone to H/V-Keystone if you want to perform
horizontal and vertical correction using the [
[ ] buttons on the control panel.
Settings - Keystone - H/V-Keystone
s
], [ ], and [ ] buttons on the
], [ ], [ ], and [ ] buttons on the
], [ ], [
p.73
a
• When Auto H/V-Keystone is set to On, the message "Do you
want to perform Auto H/V-Keystone correction?" is displayed
when the projector is moved. (EB-1775W only)
After you perform this function, the Keystone setting changes
from Quick Corner to H/V-Keystone, after which pressing
the [
panel performs H/V-Keystone.
s Settings - Keystone - H/V-Keystone
• If the [Esc] button is held down for about two seconds while
correcting with Quick Corner, the following screen is
displayed.
Reset Quick Corner: Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
s "Settings Menu"
],

Adjusting the Image Size

Turn the zoom ring to adjust the size of the projected image.
], and
], [ ], [ ], and [ ] buttons on the control
p.73
p.73
36