Basic Setup; Connect The Cameras; Connect A Monitor; Connect The Mouse - FLIR DNR200V Series Instruction Manual

BASIC SETUP

1. Connect the Cameras

a. Connect IP cameras to PoE (Power over Ethernet)
ports. OR
b. Connect IP cameras to the same LAN as the NVR.
For details on connecting IP cameras over the
LAN, see "Device Search" on page 31.

2. Connect a Monitor

a. Connect an HDMI cable (not included) from the
HDMI port on the rear panel to an HDTV or HDMI
monitor, OR
b. Connect a VGA cable (not included) from the VGA
port to the VGA port on your monitor.

3. Connect the Mouse

a. Connect the mouse (included) to one of the USB
ports on the front or rear panel.

4. Connect the Ethernet Cable

a. Connect an Ethernet cable (not included) to the
LAN port on the rear panel of system; connect the
other end of the Ethernet cable to an empty LAN
port on your router or switch (not included).

5. Connect the Power Adapters

a. Connect the DC 12V power supply to the DC 12V
port on the rear panel of the system. Connect the
power cable to an outlet, power strip, or surge
protector. This power adapter is used to power the
main unit.
b. Connect the DC 48V power supply to the DC 48V
port on the rear panel of the system. Connect the
power cable to an outlet, power strip, or surge
protector. This power adapter is used to power the
integrated PoE ports.
c. Turn the power switch to the ON position.
2
Connect IP cameras to the system
Connect to an HDMI, VGA, or BNC monitor
Connect the mouse to a USB port
Connect an Ethernet cable
Connect the power adapters
ON