Facility Names And Functions (Rear) - Hitachi CU-HD1500 Operating Instructions Manual

Facility names and functions (Rear)

13 HIGH SPEED OUTPUT connectors (BNC)
Outputs 2 sets of three times high speed
signals as LINK A, LINK B and LINK C.
[1080i, 720p]
14 HD SDI connectors (BNC)
Outputs two lines of digital serial HDTV video
signals. A trunk video output (1080i) can be
selected by CCU menu.
[1080i, 720p]
15 HD/SD SDI connectors (BNC)
Outputs six lines of digital serial HDTV/SDTV
video signals.
[1080i, 720p, SD]
The character is superimposed in PIX output.
16 D.RET input connectors (BNC)
Input digital serial AUX video signals.
RET.A: Normal Return Signal
Output from the camera viewfinder or the
camera's RET connector.
Selected by 4-position RET SEL switch on
CA-HF1500 and CCU menu.
RET.B: Continuous Return Signal
Output from
CA-HF1500.
Selected by only CCU menu.
Important notice
When using return video, please input correct
format signal, which is selected on the return
assignment menu (page 13).
HD-SDI2 connector
17 PROMPT connectors (BNC)
Input analog video signal for the prompter. The
signal is sent to PROMPT out connector on
CA-HF1500.
18 Genlock connectors (BNC)
Input tri-level sync signal or black burst signal
for genlock operation.
19 REMOTE 1,2,3 connector
Connect the optional camera control panel or
setup control unit.
20 Fiber connector
Connect Fiber cable.
21 AC IN connector
Input for AC power supply.
22 FG terminal
Frame ground terminal.
23 MIC OUT1 connector (XLR 3 pin)
Outputs MIC1 audio signals from a camera or
the CA-HF1500 at 0 dBm/600 ohm.
24 MIC OUT2 connector (XLR 3 pin)
Outputs
on
CA-HF1500 at 0 dBm/600 ohm.
25 MIC REMOTE connector
This connector is used to select the MIC1 and
MIC2 amplifier gains.
5
MIC2 audio signals from the