Reflectance Sensor; Adult And Pediatric Disposable Sensors - Respironics 920 Instruction And Service Manual

2. Reflectance Sensor

The Reflectance Sensor is for use on well-vascularized skin
surfaces. For adults, this will usually be the center of the
forehead slightly above and between the eyebrows. The Sensor
Holder provides the precise pressure this sensor needs against
the skin.
Remove the backing from one side of the double-back tape and apply
to the flange of the Sensor Holder. Then remove the back from the
other side of the tape. Press the Reflectance Sensor into the foam
with the sensor window out, and apply to the patient. Use additional
tape to secure the sensor secondarily to the patient to avoid pulling or
tipping the sensor.
E.

Adult and Pediatric Disposable Sensors

•
Do not stretch the tape while applying
WARNING
the sensor. This may cause inaccurate
readings or skin blisters.
®
The Flexi-Form Sensors are designed for monitoring adult and
pediatric patients as a single patient use sensor and are
intended for use where moderate patient movement is expected
or cross contamination is a concern.
The preferred application site is the index, middle, or ring
finger. However, the thumb or toes may be used where the
tissue thickness is between 5 and 21 millimeters. Other sites
may not give acceptable results because of inadequate
perfusion or inadequate light transmission. The application of
these sensors is the same for either the adult or the pediatric
patient. The difference is in the size of the sensor. For best
results, secure the cable independently from the sensor. Make
sure that the tape securing the cable does not restrict the blood
flow.
NOTE: Ensure sensor placement is positioned
such that no stray light bypasses the tissue
or SpO inaccuracies may result.
2
Step 1: Grip the tab on the adhesive backing on the bottom of
the sensor and carefully peel it off.
28