Connecting A Stereo Display Device - 3Dlabs Wildcat 4210 User Manual

Connecting a Stereo Display Device

Refer to your stereoscopic display device's documentation for more information on cables and
connectors.
To connect a stereo display device:
1. Connect one end of the stereo emitter cable to the input port on your stereoscopic display device.
2. Connect the other end of the stereo emitter cable to the Stereo Sync Out port on the video card (see
Figure 7).
3. Configure the display settings to enable stereo display. See Chapter 3, "Using the Video Card,"
for more information.
Figure 7. Stereo Sync Out Port (Shown On Wildcat 4210)
13