3Dlabs Wildcat 4210 User Manual page 16

10
4. When prompted to confirm driver removal, click Yes and follow the prompts.
5. When notified that driver software removal is complete, click OK.
6. Restart the computer.
To remove the existing Wildcat driver in Windows NT 4.0:
1. Log on to Windows NT using an account that has administrative privileges.
2. Go to Start » Settings » Control Panel » Add/Remove Programs » Install/Uninstall.
3. Highlight the Wildcat Display Driver and click Add/Remove.
4. When prompted to confirm driver removal, click Yes and follow the prompts.
5. Restart the computer.
After removing the currently installed Wildcat driver, you can install the Wildcat 4210 driver.
To install the Wildcat 4210 driver in Windows 2000:
1. Log on to Windows 2000 using an account that has administrative privileges.
2. When the Found New Hardware Wizard displays, click Next.
3. Under Install Hardware Device Drivers, click Search for a suitable driver for my device
(recommended), and then click Next.
4. Under Locate Driver Files, make sure the appropriate search location is selected, and that Disk 1
of the driver media is loaded in the appropriate drive (or the Disk 1 folder is selected); then click
Next. The Wizard locates the driver installation files.
5. Under Driver Files Search Results, click Next to start the installation.
6. Insert Disk 2 when prompted (or select the Disk 2 folder), and then click OK to continue with the
installation.
7. Once the driver successfully installs, click Finish to dismiss the Found New Hardware Wizard.
NOTE Windows 2000 recognizes the dual pipelines as two devices. The Found New Hardware
Wizard will display a second time to finish the installation. You must repeat Steps 3
through 7 above to complete the installation.
8. When told that the computer must be restarted for the new settings to take effect, remove the
delivery media from the disk drive (if applicable) and click Yes.
See Chapter 3, "Using the Video Card," for instructions on defining the display properties.