Table of Contents
Advertisement
3
Using the Video Card
This chapter contains instructions for configuring the video display and enabling the stereo display. If
you purchased your Wildcat 4210 video card with a computer, it was configured for use before
shipment. The instructions in this chapter are necessary only if you purchased the card separately, or if
you need to reconfigure the video display or stereo display.
Configuring the Video Display
On a computer running Windows NT 4.0, the Display Properties dialog will have two additional tabs:
Wildcat Configuration and Wildcat Monitor. On a computer running Windows 2000, go to Display
Properties » Settings » Advanced to see these tabs.
To use the Wildcat Configuration tab:
1.
Make sure you are logged into a non-VGA version of Windows NT or Windows 2000 and close
any open application programs.
2.
Go to Start » Settings » Control Panel » Display. In Windows NT 4.0, click the Wildcat
Configuration tab if it is not already displayed (see Figure 8). In Windows 2000, continue to
Settings » Advanced and click the Wildcat Configuration tab.
3.
Click Hardware Info to view hardware settings; click View Config to view the display
configuration; or click Config Wizard to modify the display configuration or create a new one.
Figure 8. Wildcat Configuration Tab
15
Advertisement
Table of Contents
