Attaching A Stereo Device - 3Dlabs WILDCAT REALIZM 800 User Manual

NOTE: If your monitor does not have a built-in video cable, use a
NOTE: If you ordered the Wildcat Realizm video card with a system,

Attaching a Stereo Device

Power off your system and connect the stereo hardware to the round, stereo connector on the card. See
the documentation that came with your stereo hardware for information on how to use stereoscopic
display. Plug in and start up your system, including peripherals, and log on to your operating system.
NOTE: To configure the display settings for stereo display, see
DVI
shielded video cable with either a DVI-I receptacle or a 15-
pin VGA video connector (with adapter) at one end for the
video output port on the card, and the appropriate
connectors at the other end for the video input port on the
monitor. See the documentation delivered with your monitor
for more information.
it was installed and configured before shipment. See
Chapter 3, "Using the Video Card," for instructions on
adjusting the resolution, color depth, and refresh rate.
Chapter 3, "Using the Video Card" for step-by-step
instructions.
3-Pin Mini-DIN Stereo Connector
3Dlabs Wildcat Realizm Graphics Accelerator User's Guide
S
ETUP
VGA
13