Table of Contents
Advertisement
18
Figure 10. Multiview Ports (Shown On Wildcat 4210)
3.
If connecting more than two computers, continue linking computers to one another by connecting
the Multiview Out port of one computer to the Multiview In port of the next. The last computer
should terminate the links and only have a cable plugged into the Multiview In port.
To confirm Multiview cables are detected:
1.
On each "slave" computer, Go to Start » Settings » Control Panel » Display » Settings.
2.
If the computer is running Windows NT 4.0, the input cables will display as Detected under
Multiview Information.
3.
If the computer is running Windows 2000, go to Advanced » Intense 3D Monitor » Multiview.
The input cables will display as Detected under Multiview Information.
To enable Genlock:
1.
Connect the external timing source to the Genlock In port on the "master" computer (see Figure
11).
Figure 11. Genlock In Port (Shown On Wildcat 4210)
Advertisement
Table of Contents
