Adding Salt - Kenwood KID60S10 Installation Instructions Manual

adding salt

If the water in your area is hard, deposits will form on your dishes
and utensils. This appliance contains a salt reservoir for you to
reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir
and it must be set to correspond to the water hardness level in your
area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Fill the reservoir with approximately 500ml of water (first use
only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt depending on the
brand used.
5. Clean any excess salt from around the reservoir opening and
then screw the cap on again firmly.
6. Run the "rapid" wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from the
compartment.
• The salt warning light will illuminate when the reservoir is
running out of salt and requires re-filling.
• The salt warning light will cease to illuminate within a few
days depending on how quickly the salt dissolves.
18
KID60S10_IB_110426.indd 18
open
open
salt warning
light
open
4/27/11 5:48 PM