Extron electronics MGP Pro Series User Manual page 125

8. If this is the only device to which you are uploading firmware, click
MGP Pro information is added to the Devices panel of the Firmware Loader dialog box,
and the Add Device dialog box closes.
If you will be uploading the firmware to multiple MGP Pro MGPs that are
connected to your computer, do the following:
a. Click . Your first device is added to the Devices panel of Firmware Loader
Add Next
dialog box, and the Add Device dialog box remains open.
b. For each additional device you want to add to the Firmware Loader dialog box,
repeat steps 4 through 7, then click
c. For the last device, click
the Add Device window.
Figure 63. Firmware Loader Dialog Box with an MGP Added
9.
If you want to remove a device from the Devices panel, do the following:
a. Click on the names of the devices to be deleted, to highlight them.
b. Select
Remove Selected Device(s)
c. On the Remove Device(s) dialog box, select or deselect any devices on the list as
desired, then click
To remove all devices, select
10. Click Begin. The following indicators show the progress of the update (see
on the next page):
The Transfer Time panel shows the amounts of remaining and elapsed time for the
•
update.
The Total Progress panel displays a progress bar with
•
In the Devices panel, the Progress column displays an incrementing percentage and
•
another progress bar. The Status column displays
.
Add Next
(instead of
Add Add Next
from the
.
Remove
Remove All Devices
MGP Pro Series • Reference Information
. The
Add
) to add the device and to close
menu.
Edit
from the menu.
Edit
figure 64
above it.
Uploading...
.
Uploading
119