Armrest Width Adjustment - Pride Quantum 610 Series Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 2.
3. Unplug the controller connector(s) from the power
base.
4. Remove the seat from the power base.
5. Remove both extrusions from the bottom of the seat.
6. Reposition the extrusions on a different set of mount-
ing holes. You must move both extrusions the same
number of holes either forward or backward. See fig-
ure 13.
7. Fasten the extrusions back onto the bottom of the seat.
8. Reinstall the seat.
9. Reconnect the controller.
10. Reinstall the rear shroud and tighten the fasteners.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seat-
back, you can adjust it to four (4) different angles: 90°,
102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge.
See figure 14.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and
tighten.

Armrest Width Adjustment

You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
Quantum 610 Series
Figure 13. Seat Position Adjustment
ARMREST ANGLE
ADJUSTING
SCREW
ARMREST HEIGHT
ADJUSTMENT
SETSCREWS
ARMREST KNOB
SEATBACK
ANGLE
ADJUSTING
SCREW
Figure 14. Seatback Angle Adjustment
www.pridemobility.com
JAM NUT
15