Pride Quantum 610 Series Owner's Manual page 13

Power Seat Option Installation
Your power chair may be equipped with the power seat
option. While the seat itself may be any one of the styles
offered for this model, the way the seat base attaches to the
power base is different.
To install the power seat:
l. Align the post on the bottom of the power seat base
over the hole in the power seat actuator.
2. Slide the post into the actuator and push the friction
lock lever forward.
3. Connect the power seat cable to the power base.
4. Tilt the seat back and slide the rear extension onto the
power seat base.
5. Lower the front extrusion onto the power seat base
until the seat locks into place.
6. Flip down the seat latch safety.
7. Install the controller.
NOTE: Refer to V. "Comfort Adjustments" for more
information on controller installation and adjustment.
Quantum 610 Series
I V . A S S E M B L Y
www.pridemobility.com
WIRE TIES
Figure 9. Controller Routed on a Contour Seat
FRICTION LOCK
LEVER
Figure 10. Power Seat Actuator
POWER SEAT
ACTUATOR
13