Armrest Width Adjustment; Armrest Height Adjustment - Pride 1170XL Plus 2VHD, 1170XL Plus 3VHD Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Manual Recline Seatback Adjustment
If your power chair seat is equipped with a reclining
seatback, you can adjust the seatback angle with the
seatback release lever. The lever is located on the right
side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired
position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable
seatback, you can adjust it to four (4) different angles:
90°, 102°, 105°, or 107°. See figure 12.
To adjust the seatback angle:
1. Remove the seatback angle adjusting screw from
each seat hinge.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to both seat hinges
and tighten.

Armrest Width Adjustment

You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the armrest knob on each side of the armrest receiver bracket. See figure 12.
2. Loosen the armrest knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the armrest knobs.

Armrest Height Adjustment

To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver. See figure 12.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Jazzy 1170 XL Plus Series
JAM NUT
ARMREST
ANGLE
ADJUSTING
SCREW
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING
SCREW
ARMREST
KNOB
Figure 12. Seatback/Armrest Adjustment
www.pridemobility.com 23