Download  Print this page

Tips On Drying Laundry - Mitsubishi Electric MJ-E15BX-A1 Instruction Manual

Hide thumbs

Advertisement

Tips on Drying Laundry

To dry laundry quickly and neatly
How to Hang Clothes
Fully extend the clothes to remove any wrinkles.
Leave space between clothes to allow air to easily pass
through them (Guideline for spacing: Approximately 5 cm)
Hang any diffi cult to dry items in positions where air fl ow
can easily come into contact with them.
Clothes placed close together will take a longer time to dry.
Drying times will vary depending on the nature and the quantity of the
laundry and the room temperature
When there are a lot of clothes
When the room temperature is low P3
The drying time required at a low temperature (approximately 10°C)
is around twice that at a normal temperature (approximately 20°C).
In large room P12
How to Direct Air Flow at Clothes
Use the swing louvre to direct air onto all clothes
Clothes placed in locations that are not exposed to the wind
will take time to dry.
When there are a lot of clothes
Change the hanging positions of the clothes during drying to
ensure air is blown onto all clothes.
About the Room for Hanging Clothes
Hanging the clothes in a small enclosed room allows for
very effi cient dehumidifying and quick drying.
When the room temperature is low such as during winter
Drying becomes easier if you also use a heater to raise the room
temperature to approximately 16°C or more.
Using the unit to dry clothes hung in a room is recommended on days such as
the following.
Cloudy and rainy days
Drying clothes hung outside takes
a while on days with high humidity
because it is diffi cult for water to
evaporate.
Days with a lot of pollen
and dust in the air
Hanging clothes inside enables
you to prevent pollen and dirt
getting on them.
Days you are unable
to bring in the washing
during daylight hours
Dry clothes absorb dampness
when the air cools outside after the
sun sets, meaning your efforts will
have gone to waste.
13

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: