Drying Laundry; Intelligent Laundry - Mitsubishi Electric MJ-E160HR-H Instruction Manual

Drying Laundry

When in the operation of INTELLIGENT LAUNDRY, the unit will estimate the laundry drying time and stop
automatically.
1
Press
z POWER lamp lights.
z The operation mode is displayed.
z Louvre opens, and blows air.
Blip
2
Press

INTELLIGENT LAUNDRY.

z A border is displayed around
INTELLIGENT LAUNDRY
z It is impossible to preset humidity when
in INTELLIGENT LAUNDRY mode. In
INTELLIGENT LAUNDRY mode, press
HUMIDITY SELECTION switch to change into
AUTO mode.
3
Press
direction.
<To stop operation>
Press
z POWER lamp goes out.
z The operation mode indicator goes out.
z If the DRYING INSIDE (auto) operation has
been activated, the DRYING INSIDE operation
will start after the unit stops.
10
3
Blip
to select
P13
and select the swing
P16
Blip
P18
2 1
z After the unit stops or the power plug is
inserted, the compressor will not be activated
(for compressor protection). The dehumidifier
will begin to work in 3 minutes after pressing
the POWER switch. The noise emitted from the
unit will become louder when the unit begins to
dehumidify.
z The dehumidifier remembers the operation mode.
Even if the power plug is disconnected or the power
is turned off, the unit restarts at the previous setting.
• INTELLIGENT LAUNDRY
The unit controls the airflow rate while monitoring
the humidity in the room, and then estimates the
laundry drying time and stops automatically.
Operation time is approximately 1 hour and can
be up to approximately 12 hours.
Operating each operation mode
Operation mode
INTELLIGENT LAUNDRY
z Remove the water from the tank before
operating the unit.
The unit may stop operating when the tank is full
before the laundry is dry.
z When it is used with the OFF TIMER operation
mode, the unit may stop operating before the
P17
laundry is dry.
z If the room temperature is approximately 5°C or
less, it becomes difficult for water to evaporate
from the laundry, and the operation will stop in
around 1 hour.
At this time, please use the HIGH operation mode.
Automatic stop
 (Operates for 1 to 12 hours)