To Dry The Inside - Mitsubishi Electric MJ-E26VX-A1 Instruction Manual

To dry the inside

The inside of the unit can be dried to suppress mildew growth on the cooler.
On days the dehumidifier is used, internal drying (drying the inside) is recommended.
Automatic operation
To activate internal drying after every use.
Press
¡Internal drying standby
(Mildew guard elite lamp lit)
Internal drying starts when operation ends
When the unit is turned off, LAUNDRY mode
ends, or the OFF timer ends.
¡Internal drying starts
The mildew guard elite lamp flashes, the
humidity indicator turns off, and the louvre
stops in the vertical position.
Internal drying mode
¡Internal drying ends
The mildew guard elite lamp turns off and the
louvres shut.
<To deactivate automatic operation>
Press the MILDEW GUARD ELITE button while the
unit is on (the mildew guard elite lamp turns off)
∞ Turning off at the wall deactivates automatic operation.
∞ This function does not remove existing mildew. Also, aborting internal drying may cause the benefits to
diminish.
∞ Do not close the louvres while internal drying as this causes noise.
∞ The moisture expelled from inside the unit may cause the humidity level of the room to rise.
∞ The air leaving the unit may appear white depending on the humidity or temperature of the room.
∞ The moisture expelled from inside the unit may smell due to odorants* that were not caught by the filter
dissolving in the water.
* The photocatalytic filter is mainly for absorbing ammonia.
∞ The OFF timer cannot be set during internal drying.
<Internal drying operation>
OFF
Regular
operation
Airflow
Dehumidifier
Approx.
Air purifier
30min.
while the unit is on
This operation takes approximately one hour. However, when the room
temperature is below 1°C, drying time is shortened to protect the compressor.
Internal drying operation (approx. one hour.)
Airflow stops; compressor
activates (operating sound)
Compressor operates
according to room temperature
Manual operation
To activate internal drying by pressing a button.
Press
¡Internal drying starts
The mildew guard elite lamp flashes, the
humidity indicator turns off, and the louvre
stops in the vertical position.
Internal drying mode
¡Internal drying ends
Mildew guard elite lamp turns off and the
louvres shut.
To abort internal
drying
Press mildew guard elite button while the unit
is performing internal drying (the mildew guard
elite lamp turns off)
Press the power button to abort internal drying,
and resume normal operation.
Operating
Compressor
sounds
stops
Approx. 20min.
while the unit is off
Unit
stops
Airflow
auto-
mati-
Approx.
cally
10min.
17