Drying Inside Operation - Mitsubishi Electric MJ-E100AR-H Instruction Manual

Drying Inside Operation

The inside of the unit can be dried to suppress mildew growth on the cooler.
The DRYING INSIDE operation is recommended after each use of the unit (approx. one hour).
However, when continuous operation is being performed by continuous drainage (setting hose), there is no need to
perform the DRYING INSIDE operation. Perform it when the operation is stopped.
Automatic Operation
To activate DRYING INSIDE operation after each use
z DRYING INSIDE operation standby
(DRYING INSIDE lamp lights.)
DRYING INSIDE operation starts when
dehumidifying ends.
z DRYING INSIDE operation starts.
The DRYING INSIDE lamp flashes, the
humidity indicator turns off, and the louvre
stops in the vertical position.
z DRYING INSIDE operation ends.
The DRYING INSIDE lamp turns off and the
louvre closes.
<To deactivate the automatic operation>
Press the DRYING INSIDE switch when the
POWER is ON.
(The DRYING INSIDE lamp turns off.)
z Disconnecting the power plug will stop the automatic operation.
z This function does not remove existing mildew. Also, aborting the DRYING INSIDE operation may cause the benefits to
diminish.
z During DRYING INSIDE operation, do not close the louvre. It will cause noise.
z The moisture expelled from inside the unit may cause the room humidity level to rise.
z The air emitting from the unit may appear white depending on the humidity or temperature of the room.
z The moisture expelled from inside the unit may have a smell due to odorants, which have not been caught by the filter and
dissolve in water.
* The silver ion filter is mainly for absorbing ammonia.
z During DRYING INSIDE operation, the OFF TIMER cannot be set.
z If operation is stopped while the FULL lamp is lit, the DRYING INSIDE operation cannot be set unless the power is turned
off.
18
Blip
Press while the
POWER is ON
DRYING INSIDE Operation
Manual Operation
The DRYING INSIDE operation can only start
when the POWER is OFF.
z DRYING INSIDE operation starts.
The DRYING INSIDE lamp flashes, the humidity
indicator turns off, and the louvre stops in the
vertical position.
DRYING INSIDE Operation
z DRYING INSIDE operation ends.
The DRYING INSIDE lamp turns off and the
louvre closes.
To abort DRYING
INSIDE operation
Press the DRYING INSIDE switch while the unit
is performing the DRYING INSIDE operation (the
DRYING INSIDE lamp turns off).
Press the POWER switch to abort the DRYING
INSIDE operation and resume the regular
operation.
Blip
Press while the
POWER is OFF