Clear Call-History; Codec - Zte ZXR10 Command Manual

ZXR10 Command Manual (Voice and Video Service Volume)
Syntax
Defaults
Instructions
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
8 Confidential and Proprietary Information of ZTE CORPORATION
cancel-truncate
no cancel-truncate
If this area is configured, it is truncated by default.
� This command is only applied to the dial-peer in pots type.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.

clear call-history

Use this command to clear the call history information of the spec-
ified port.
Privileged EXEC
clear call-history voice-port <voice-port>
<voice-port>
It is only applied to ZXR10 GAR and ZXR10 ZSR.

codec

Use this command to configure the voice coding rate of a dial-peer.
Restore the default configuration with the no command.
Dial-up peer configuration
codec {g711alaw | g711ulaw | g7231 | g729}
no codec
g711alaw
g711ulaw
g7231
g729
If this area is configured, the voice coding rate of a dial-peer is
g729 by default.
� This command is only applied to the dial-peer in voip type.
�
The modified dial-peer configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to configure the voice coding rate of
a VOIP dial-peer 100 as g711alaw.
Specifies the voice port.
G.711 A-law 64000bps
G.711 u-law 64000bps
G.723.1 6300bps
G.729 8000bps