Connecting To The Fiery - EFI Splash RPX-i Troubleshooting Manual

T
ROUBLESHOOTING

Connecting to the Fiery

If you cannot connect to the Fiery, do the following.
• Check the Fiery IP address.
To confirm the IP address, print a Configuration page, or consult your network
administrator.
• Type the IP address manually. The Fiery may be on a different subnet.
• Try connecting to a different Fiery controller for the DocuColor 250/240.
• If nothing prints, check that port 9100 on the Fiery is enabled in Network Setup.
Quit the Splash RPX-i, restart the Fiery, and then restart the Splash RPX-i.
For information about port 9100 on the Fiery, see Configuration and Setup and Printing
from Windows on the DC240/250 User Documentation CD.
• Check for issues with the Direct Connect Activation Key.
For more information, see
"Replacing the Direct Connect Activation Key"
• Restart the Fiery (see "Restarting the Fiery"
"Checking the Direct Connect Activation Key"
on page 12.
on page 13).
10
on page 11 and