If The Tv Remote Control Does Not Work Properly After The Center Unit Is Installed 2-Channel Playback (Stereo Playback Mode); Delivering Sound To A Specified Location (Target Playback Mode); Enjoying Surround Sound With Headphones - Yamaha YSP-2500 Owner's Manual

2-channel playback (stereo playback mode)
The front channels are the primary channel sources for output of
SURROUND
stereo sound.
STEREO
TARGET
1
Press the STEREO key to switch to stereo playback
mode.
Delivering sound to a specified location
(target playback mode)
Target playback mode outputs sound beams from a single channel
for optimal listening from a specific position.
Refer to the illustrations below.
For listening at low volumes, such as at night
/
For clear sound at a distance
Beam angle can be adjusted while audio or video content is
playing.
1
Press the TARGET key.
2
Use the / key to adjust beam angle.
The angle to the left increases by 2 degrees each time the
key is pressed; the angle to the right increases by 2
degrees each time the key is pressed.
A maximum angle of 90 degrees in either direction is
possible.
Beam angle adjusted 16 degrees to the left
TARGET L16
Disabling target playback mode
Press the SURROUND key or STEREO key to turn target playback
mode off.
• The CINEMA DSP programs are not available in target playback mode.
• Bass output is controlled to prevent sounds from spreading in other directions.

Enjoying surround sound with headphones

Plug the headphones into the PHONES jack.
The Virtual Surround Headphones technology virtually reproduces
surround sound and stereo audio content in the same way it is
reproduced for audio playback through speakers (p. 44). The
CINEMA DSP (p. 40) can also be utilized.
• Headphones volume and tones (BASS/TREBLE) can be configured separately
from speaker configuration (p. 64).
PLAYBACK ➤ Enjoying sound based on your preference
44
En