Remote Control; Messages - Yamaha YSP-2500 Owner's Manual

Remote control

Problem
The remote control does not work The wrong distance or angle.
and/or function properly.
Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this unit.
The batteries are weak.
The TV cannot be operated using The TV Remote Repeater function is disabled.
the TV Remote Repeater function.
A remote control using technology other than infrared is used (this unit may
not support some infrared remote controls).
The center unit and TV are too close together or too far apart.
The center unit's power cable is unplugged.
There is an object, such as a power cable, between the center unit and TV.

Messages

Message
ViewScreen This unit's setup menu is displayed on the TV screen. Use the TV screen to configure settings.
Key Locked The keys on the center unit are locked. Use the remote control.
Sleep XXmin The Auto Power Standby function will turn this unit off in XX minutes.
Protected System memory 1, 2, and 3 are protected.
Disable Key operation is disabled.
Cause
The remote control functions within a maximum range of 6 m (20 ft) and no
more than 30 degrees off-axis from the front panel.
Reposition this unit.
Replace all batteries.
Enable the TV Remote Repeater function.
The TV Remote Repeater function cannot be used. Move the center unit so
that it does not block the remote control sensor on the TV, and use the TV's
remote control to operate the TV.
Move the center unit to adjust the distance between the TV Remote
Repeater and the TV (remote control sensor). If necessary, adjust the height
of the center unit.
Plug in the power cable.
Remove the obstacle.
Description
Remedy
TROUBLESHOOTING ➤ Messages
See page
23
–
23
15
–
16
28
–
See page
51
65
65
65
–
72
En