Figure 2-12. Removing The Display - HP OmniBook XE3 Service Manual

Screws,
M2.5x4 mm
Reassembly Notes
• While installing the hinge screws, support the display so that it remains approximately flat.
• Before installing the switchboard PCA, make sure the large display cable lies within the notch in
the hinge saddle.
• When in stalling a new display assembly, follow the procedure given in "Installing a New Display
Assembly" on the following page.
2-18 Removal and Replacement
Screws (flanged)
M2.5x8 mm (4)

Figure 2-12. Removing the Display

HP OmniBook XE3