Figure 2-4. Removing An Sdram Module - HP OmniBook XE3 Service Manual

3. Press outward to release the latches at the sides of the SDRAM module, so the free edge of the
module pops up.
4. Pull the module out of the connector.
Reassembly Notes
• Gently press the SDRAM module into the connector at an angle of about 30°, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.
2-6 Removal and Replacement

Figure 2-4. Removing an SDRAM Module

HP OmniBook XE3