Assembly Instructions - Schwank 4001-J SERIES Installation & Owner's Manual

5. ASSEMBLY INSTRUCTIONS

Wheel brackets curve 'up'
Attach Wheel Kit to base:
•
Assemble wheel brackets to base 'L' brackets using four #8 x
3/4" bolts and nuts (Note: Bolt heads face the wheel; Position
wheel brackets with curve "up")
•
Align pairs of holes in each end of 'L' brackets to those in op-
posite sides of the base - fasten in place with #8 x 3/4" bolts
& nuts. (NOTE: Position wheel brackets with curve "up")
•
Assemble wheels to wheel brackets using axle bolts & nuts
NG Model Only: Install #10 x 1 1/4" bolt up though the hole in
top of cylinder base - opposite the wheel assemblies
•
Place washer on bolt
•
Insert up through hole in top surface of base
•
Fasten with washer and nut
•
Finger tighten the second nut in place for later use
Attach the 3 post mounting brackets on
to the Cylinder Base as shown. Use 3-M8
x 15mm bolts to secure brackets to the
Fasten the post onto the top of the post
brackets, aligning pre-drilled holes as
shown.
Use six - M6 x 35mm bolts, washers &
nuts to attach post to post brackets.
Tighten securely
.
Page 8
GP-M40J-CX-08A
4001/2-J, 4N11/2-J Manual
RD: April 2006
R.L. 08A
KH