Introduction; Safety Instructions - Schwank lunaSchwank 6 Technical Instruction

lunaSchwank
General
Setup and functioning of this gas-infrared heater
conform to the applicable standards and safety
regulations in the European Union.
We request you to read this technical instruction
carefully before using the device. Following the
instructions and information mentioned here is a
prerequisite for our warranty and is necessary for
enabling a proper installation and a fault-free
operation.
The high-power heater lunaSchwank is meant
exclusively for heating open areas and well
ventilated rooms. Any other use or a use over and
above this is considered as improper. SCHWANK
GmbH will not be liable for resulting damages. The
user alone will bear the resulting risk.

Safety instructions

This device is built according to state-of-the-art
technology and the legally recognised safety rules.
Still, in case of improper use, there can be hazards
for the user or for a third party or an impairment of
the device and loss of other assets.
General safety instructions

Use the device only in the proper way and in a
technically fault-free state.

Make sure that all persons operating,
mounting, installing, commissioning, servicing
or repairing this device have read the technical
instruction. Please preserve the technical
instruction at the place of use.

Pay attention to the generally applicable legal
and other binding rules of accident prevention.

Do not make any changes or build structures
on or around the device without the explicit
permission of SCHWANK.

All spare parts must conform to the technical
requirements. For this reason, use only the
original spare parts.
Safety instructions for electrical
equipment
4
Technical Instructions

Electric shock hazard!
You can get fatally wounded through electric
shocks.

Work on the electrical equipment of the device
may be done only by a skilled electrician in
accordance with the electro-technical rules.

Regularly check the electrical equipment.
Braised cables, etc. must be replaced
immediately.

Switch the device free of voltage when working
at the electrical equipment. Safeguard the
device against an unintentional switch-on.
Safety while working with the device
Mounting, installation, initial commissioning, repair
and maintenance work may be done only by a
contractual installation company [VIU] qualified and
authorised for this.
If you have any queries, please get in touch with
the respective customer service of SCHWANK.
Safety during mounting and
installation

Please follow the TECHNICAL RULES,
worksheet G 638/I of DVGW.

According to G 638/I, the initial commissioning
may be done only by the manufacturer or by
an authorised VIU.

Fire hazard!
Please adhere to the safety distances [see
page 4 and 5] during mounting, see to it that
the ignition device is easily accessible.

Lay the gas and electrical lines in such a way
that they cannot get heated by the rising
exhaust gases or by the direct heat radiation.
Only the heat-resistant cables may be used
near the heater.