Programming Instructions For Settings 2 Menus; Programming Heating Cycles - Jacuzzi J - 480 Owner's Manual

13.0 Programming Instructions for settings 2 menus

The "Settings 2" screen allows you to program Heating, Primary Filter
and Secondary Filter modes.
13.1

Programming Heating Cycles

Your Jacuzzi spa is equipped with two modes of heating. An
automatic mode called "Auto-Heating", where the spa's temperature is
maintained at all times by the "Setpoint". The second mode is called
"Programmable", where the spa will only activate the heater at set times
programmed by you. To activate either mode follow the procedures
below.
To access the "Settings 2" Menu:
1. From the Settings 1 Menu (Figure A), press button B.
2. The "Settings 2" Menu will appear (Figure B).
note: You can return to the factory default heating and filtration modes
by pressing the Splash button on the Quad Keypad while in the Settings
2 Main Menu (Figure B) at any time.
Figure A
Figure B
A
B
A
B
SETTINGS 1
Language
ENG
Ozone
Filter
OFF
Press to
set filter timer
SETTINGS 2
Primary
Secondary
OFF
Heating
Press to
reset to default
J-400
C
D
C
D
Page 59