Continuous Or Slow Spinning; Siphoning - Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual

517790C
•
If the inner bowl or agitator are noisy, check for obstructions. Check the spline drive is clean.
If there is a grating sound, check the single stainless steel washer beneath the spline drive.
•
If the motor is abnormally noisy, chipped or cracked Rotor magnets are unlikely to affect the
noise.
•
If the pump is noisy, check for obstructions. Change parts as necessary.
13.4

Continuous or Slow Spinning

The most likely cause of slow or continuous spinning is 'Out of Balance'. To correct this, refer to
section 4.8.5.
Too much detergent can cause final spin to stop and respin 4 times. This is due to suds build up
between the bowls, and normally will sound a User Warning.
A more likely cause of slow spinning is the Hot Bowl Flag (Refer to Section 4.6).
13.5

Siphoning

Typically this occurs when the Standpipe height is too low. The minimum is 850mm from the floor.
This is 90mm ABOVE the drain hose outlet on SmartDrive
high water level, this could result in water pouring down the standpipe prior to SmartDrive
completing fill and resulting in no water in the bowl during agitate.
If the drain hose is pushed too far into the standpipe or drain, SmartDrive
which could result in a 'No Taps' user warning.
Siphoning can result from a restricted drain hose or partial pump block.
®
. With a very low standpipe and a very
61
®
will siphon during rinse,
®